スポンサーリンク
Technical Research Center, Mazda Motor Corporation | 論文
- Automotive Basecoat with High Flip-flop
- A study on the formation of vertical vortex in the cylinder of an I.C. engine using CFD : Effect of intake valve closing timing
- An evaluation method for quality of air-fuel mixture distribution and movement in combustion chamber of DISI engine using CFD
- Mixture formation of direct gasoline injection engine : in-cylinder gas sampling using fast flame ionization detector
- Analysis of mixture formation on combustion chamber wall of direct injection stratified charge engine
- Measurement of vehicle attitude with PTK-GPS for analyzing the vehicle motion behavior
- A study on driver model for lane change judgement
- Remarkable Hydrogen Storage, Structural and Optical Properties in Multi-layered Pd/Mg Thin Films
- Measurement of ion current in homogeneous charge compression ignition combustion(HCCI, Combustion Processes II)
- GDN-23 ANALYTICAL APPROACH OF TRANSMISSION GEAR NOISE(GEAR DYNAMICS AND NOISE)
- Development of High Quality Appearance Basecoat : Appearance Improvement Technology of Three-layer Wet Paint System
- Development of Eco-friendly Coating Technology : Paints and Coating System for Primer/Top Coat Wet-on Coating
- Effect of combustion chamber shape on tumble flow, squish-generated flow and burn rate
- HC reduction system for cold start and warm-up phases - Improvement of catalyst warm-up by retarded ignition
- Transient analysis of geared neutral type half-toroidal CVT
- Influence of mixture preparation on HC emission of SI engine with high swirl ratio under cold conditions
- Development of Bioplastic for Automobile Parts
- Analysis of driver response to collision warning during car following
- Algorithm for detection of right-turn initiation at intersections to optimize the content and timing of provided information
- Development of magnesium forged road wheel