スポンサーリンク
Faculty of Engineering Fukuoka University | 論文
- In vivo evaluation of the improved MCMS-0102 pacemaker with a rapid pacing mode for induction of experimental heart failure in animals
- Detection of skeletal muscle fatigue using an accelerometer in dynamic cardiomyoplasty
- Heart failure in the dog induced by rapid ventricular pacing using a newly designed cardiac pacemaker, MCMS-0102
- Experimental Studies on the Turbulent Burning Velocities of Premixed Mixtures in a Closed Bomb : Influence of Oxygen Concentration and Ignition Energy
- Influences of Swirl and Turbulence on the Burning Velocity in an Engine Cylinder : 2nd Report, Experiment with Single-compression Test Equipment
- Vortex Design of a Diagonal Flow Impeller with High Specific Speed
- An Analysis Using Offset Curves for Profiles, Manufacturing and Errors of Plane Cams
- On the Spectral Theory of Turbulent Combustion
- A DESIGN OF AXIAL-FLOW COMPRESSOR BLADES WITH INCLINED STREAM SURFACE AND VARYING AXIAL VELOCITY
- EFFECT OF BLADE THICKNESS ON THE TWO-DIMENSIONAL CASCADE PERFORMANCE : Correcting Method for Design Camber and Stagger
- An Experimental Study on the Exhaust Smoke of a Diesel Engine with Variable Angle Swir1er
- Influences of Swirl and Turbulence on the Burning Velocity in an Engine Cylinder : 1st Report, On the HoT-wire Measurement of the Instantaneous Gas Velocity in a Cylinder
- Position and Orientation Control of a Wheeled Inverted Pendulum
- Experimental studies on improvement of lubrication for cam and follower
- Characteristics of Piston Ring Friction : Influences of Lubricating Oil Properties
- Experimental Studies on Friction and Scuffing Resistance of Ceramics for Cylinder Linear and Piston Ring
- Lubrication of a Crosshead-Pin Bearing in a Two-Stroke Cycle Engine : Analysis of the Bearing with an Elliptical Bearing Surface
- Studies on the Load Carrying Capacity of a Crosshead-pin Bearing in a Two-stroke Cycle Diesel Engine
- On the Lubrication of Crosshead-Pin Bearing with Eccentric Journal : Analysis for the Case with both Eccentric Journal and Bearing
- On the Lubrication of Crosshead-pin Bearing with Eccentric Journal