スポンサーリンク
Department of Mechanical Engineering Faculty of Engineering Okayama University | 論文
- Continuous Recognition Method for Japanese Finger Letters Using Contour Feature
- Fundamental Study on Continuous Ice Making Using Flowing Supercooled Water
- Phase Transformation of α" Martensite Structure by Aging in Ti-8mass%Mo Alloy
- Tensile Behavior and Cold Workability of Ti-Mo Alloys
- Wide Range Observation on Crystal Zone of Single Variant of R-phase and Martensite in Ti-50.4 at%Ni Alloy
- Evaluation of Bonding State of BCC(Fe) Edge Dislocation Core by DV-Xα Cluster Method
- Solid Solubility and Transformation in Mechanically Alloyed Ti-Mg Powders
- 226 COMPLEX REAL SIGNAL MOTHER WAVELET AND ITS APPLICATION ON EXTRACTION OF ABNORMAL SIGNALS(General Session IV)
- Stereotactically Inserted Tube-Guided Brain Biopsy Using Positron Emission Tomography and Magnetic Besonance Coregistered Images : Case Report
- Human Characteristics of Pair Assembly Work in a Microgravity Environment
- Slip Flow over a Smooth Platinum Surface
- Data Analysis in Unsteady Turbulent Flow Measurement : Preliminary Study of Data Analysis of Turbulent Flow in Engine Cylinder
- Bifurcation diagram for two-dimensional steady flow and unsteady solutions in a curved square duct
- Combined Use of TruFill DCS Detachable Coil System and Guglielmi Detachable Coil for Embolization of Meningioma Fed by Branches of the Cavernous Internal Carotid Artery : Technical Case Report
- Laminar flows through a curved rectangular duct over a wide range of the aspect ratio
- Experimental study of the flow in a helical circular tube
- Taylor-Dean flow through a curved duct of square cross section
- Stability of the flow in a helical tube
- Measurement of hydrocarbon fuel concentration by means of infrared absorption technique with 3.39μm He-Ne laser
- An Evidence of Small Domain Superlattice in Cu-10.37 at% Al Solid Solution Alloy